E101AP-2i is a DIN rail network analyzer suitable for single-phase connection with 10A current input. However, it’s possible to set CT and VT ratios at will for higher currents and voltages. It’s equipped with two digital outputs that can be used as alarm or pulse outputs (for energy), an analog input for process signal acquisition, a RS485 Modus RTU serial output that allows remote monitoring of all measurement and configuration parameters. Its small size allows to use this devices even in switchboards with limited space. E101AP-2i is the ideal instrument for monitoring all the electrical parameters of a single-phase line (voltages, currents, frequency, active – reactive – apparent powers, energies, phase angle, etc.) and provides the RMS measurements as well as the fundamental measurements ( in accordance with IEEE 1459-10). The analogue outputs (insulated from each other) allows to send, via process signals (0 … 20mA – 4..20A – 0 … 5mA – 0 … 10V etc), the value of the measurement made by the analyzer to acquisition systems such as PLC or other instruments. It’s also equipped with an SD memory card for datalogger. The module can be configure via DIP SWITCH, via the RS485 serial interface or via smartphone (using the E-WSET accessory module). All the products in the ESAM E10X automation modules line support the TBUS connection which allows multiple devices to be connected by adding functionality to the module itself (e.g. by introducing a module for universal I / O management: E101U), reducing wiring and guarantees control of all devices connected to the bus by a single module.

Single-phase network analyzer for DIN rail with RS485 ModBus RTU serial interface, analog outputs and analog input

  • Single-phase 10A
  • Accuracy 0,2% of f.s.
  • RS485 ModBus RTU serial interface
  • ModBus TCP/IP on Ethernet
  • Two analog insulated outputs (loop powered or load independent)
  • Two digital outputs
  • SD memory card for datalogger
  • Aux. power supply: 18…48 Vac/dc

Data Sheet

User Manual

Catalog

Software

Recommended accessories…

Accessori consigliati

  • E-CONNECT

    Gateway RS485 ModBus RTU – ModBus ModBus TCP/IP

    • RS485 ModBus RTU Serial interface
    • ModBus TCP/IP on Ethernet
    • Aux. power supply: 18…48Vac/dc

     

  • ESK 41.4

    Cable or bus bar current transformer

    • Accuracy: 0,5%
    • Cable dimension: 32 mm
    • Bus bar dimension: 40 x 10 mm
    • Range: 250 … 800A
  • T-BUS

    Accessory for T-BUS connection

    • Compatible with all products in the E10X series

You may also like…

  • M401-M

    DIN RAIL multifunction meter, single-phase connection with RS485 ModBus RTU serial interface

    • Single-phase with display
    • Accuracy 0,2% f.s.
    • RS485 ModBus RTU serial interface
    • Two alarms outputs

     

  • M401-E

    DIN RAIL multifunction meter, single-phase connection with RS485 ModBus RTU serial interface and ModBus TCP/IP Ethernet interface

    • Single-phase with display
    • Accuracy 0,2% f.s.
    • RS485 ModBus RTU serial interface
    • ModBus TCP/IP on Ethernet
    • Two alarms outputs
  • E102P-2i

    DIN rail I/O module for analog signals with RS485 ModBus RTU serial interface

    • Accuracy: 0,2% f.s.
    • RS485 ModBus RTU serial interface
    • Two analog inputs
    • Two insulated analog outputs (loop powered or load independent)
    • Two digital outputs (insulated  from each other)
    • SD memory card for datalogger
    • Aux. power supply: 18…48 Vac/dc