MT-Cdc Z is a direct current transducer that converts the current signal present in the system into an analog process signal (0 … 5mA – 0..20mA – 4 … 20mA – 0 … 10V etc.) suitable for acquisition by PLC or data management systems. The MT-Cdc Z transducer allows to measure only a portion of the input current (ex: ± 30%). It’s able to guarantee high insulation (2kV) between input and output and to perform measurements with acquisition times <50 msec (option), high accuracy class (0.5% or 0.2%) by managing signals up to 10A. It can be supplied with RS485 ModBus RTU serial interface which allows remote monitoring of all measurement and configuration parameters. When supplied with a serial interface, the transducer can be configured using PrTrasd software with which it is possible to set the input range, output range, perform output tests, etc. The auxiliary power supply of the instrument allows it to be used both in systems powered by mains voltage and in systems powered at 24Vdc by having an 18 … 60 Vac / dc extended range power supply on board.

DIN rail transducer for direct current with extendedrange – aux. power supply execution

  • One channel 10A max
  • Accuracy 0,5%
  • RS485 Serial interface
  • Analog output
  • Insulation 2kV

Data Sheet

User Manual

Catalog

Software

Recommended accessories…

Accessori consigliati

  • E-CONNECT

    Gateway RS485 ModBus RTU – ModBus ModBus TCP/IP

    • RS485 ModBus RTU Serial interface
    • ModBus TCP/IP on Ethernet
    • Aux. power supply: 18…48Vac/dc

     

  • MT232485

    RS232 – RS485 signal converter

    • RS485 serial Interface
    • RS232 serial interface
    • Aux. power supply: 115/230Vac or 20…60Vac/dc
  • Trasformatori e Shunt

    SHUNT-2

    SHUNT /60mV – /100mV – /150mV DIN Series

    • Accuracy: 0,5%
    • Output signal : 60mV – 100mV – 150mV
    • Range: 30…200 A

You may also like…

  • MT-CdcTRMS

    DIN rail transducer for TRMS direct current – aux. power supply execution

    • One channel 10A max
    • Accuracy 0,5%
    • TRMS input
    • RS485 Serial interface
    • Analog output
    • Insulation 2kV
  • MT-Cdc

    DIN rail transducer for direct current – aux. power supply execution

    • One channel 10A max
    • Accuracy 0,5%
    • RS485 Serial interface
    • Analog output
    • Insulation 2kV
  • E101P-2iE

    DIN rail insulator for analog signals with RS485 ModBus RTU serial interface and ModBus TCP/IP on Ethernet

    • Accuracy: 0,2% f.s.
    • RS485 ModBus RTU serial interface
    • ModBus TCP/IP on Ethernet
    • Two insulated analog outputs (loop powered or load independent)
    • Two digital outputs (insulated from each other)
    • SD memory card for datalogger
    • Aux. power supply: 18…48 Vac/dc