MT-PF43 is a power factor transducer, suitable for unbalanced 4 wires three-phase systems, which converts the signal taken from the system into an analog process signal (0 … 5mA – 0..20mA – 4 … 20mA – 0 … 10V etc.) suitable for acquisition through PLC or data management systems. The MT-PF43 transducer is the ideal solution for all types of systems, it’s able to guarantee high insulation (4kV) between input and output and to perform measurements with acquisition times <50 msec (option), high accuracy class (0.5% or 0.2%) and manages signals up to 500V – 10A. It can be supplied with RS485 ModBus RTU serial interface which allows remote monitoring of all measurement and configuration parameters. When supplied with a serial interface, the transducer can be configured using PrTrasd software with which it is possible to set the input range, output range, perform output tests, etc. The auxiliary power supply allows it to be used both in systems powered by mains voltage and in systems powered at 24Vdc by having an 18 … 60 Vac/dc extended range power supply on board.

DIN rail power factor transducer – unbalanced 4 wires three-phase connection

  • Three-phase 500V 10A max
  • Accuracy 0,5%
  • RS485 ModBus RTU Serial Interface
  • Analog output
  • Insulation 4kV

Data Sheet

User Manual



Recommended accessories…

Accessori consigliati

  • CM-MT10

    Terminal covers for transducer series


    Gateway RS485 ModBus RTU – ModBus ModBus TCP/IP

    • RS485 ModBus RTU Serial interface
    • ModBus TCP/IP on Ethernet
    • Aux. power supply: 18…48Vac/dc


  • ESK 13.AN

    Cable or bus bar current transformer

    • Accuracy: 0,5%
    • Cable dimension: 2 x 50 mm
    • Bus bar dimension: 3 x 100 x 10 mm
    • Range: 2000 … 4000A

You may also like…

  • MT-UN43

    Universal DIN rail converter – unbalanced three-phase 4 wires connection

    • Three-phase – 500V 10A max
    • Accuracy0,5%
    • RS485 ModBus RTU Serial interface
    • Analog output
    • Insulation 4kV
  • E101A-E

    Single-phase network analyzer for DIN rail with RS485 ModBus RTU serial interface, ModBus TCP/IP on Ethernet interface and analog outputs

    • Single-phase 10A
    • Accuracy 0,2% of f.s.
    • RS485 ModBus RTU serial interface
    • ModBus TCP/IP on Ethernet
    • Analog output (loop powered or load independent)
    • Two digital outputs
    • SD memory card for datalogger
    • Aux. power supply: 18…48 Vac/dc